PMDG 737-700 Custom Views (Installation Path Below)
Screenshots are sequential to the views based on key ALT-*.... Alt-1 to Alt-7 are cockpit views with minimal transitional movement and good view flow while Alt 8 to Alt-0 are cabin views.... Will be working on similar packages for all PMDG 737 Versions with some views remaining the same and some different for more variety.... Reinstalled due to SU10 and forgot to back up, therefore have to start this tedious process from scratch again.... With that in mind, uploading after creating for a reference backup....
C:\Users\***\AppData\Roaming\Microsoft Flight Simulator\SimObjects\Airplanes
PMDG 737-700 Custom Panel States (Installation Path Below)
Panels States of 5 are included... First and Second are Jetway Startups... Third and Forth are Stairs only... Fuel is set low for Progressive GSXPro Fueling... GPU Only means the ground power unit is connected, the ground power is on in the overhead, air conditioning unit connected/on and requires an almost cold/dark startup but the cockpit lights are set up already for night flight loading... FMC Startup means that the overhead panel is basically ready and a few other steps as well. With these, do not forget to place your GPS Co-Ordinates into the FMC and then on the overhead turn the NAV dials... PACS & YAW are off as well as APU Bleed ON for Startup so do not forget to work the overhead PACS & YAW System after successful engine startup... Those two states is for a very fast SimBrief FMC Input and off you go... The Final fifth panel state is basically only Battery Only/Jetway Enabled/Low Fuel/Cockpit Lights/Dome Light and no ground sevices as close to a cold state as possible but saving a little time on setup if doing a night flight.
C:\Users\***\AppData\Roaming\Microsoft Flight Simulator\Packages\pmdg-aircraft-737\work