First things first:
If any problems arise, please contact me before writing bad comments or giving one star ratings. ;)
>>>> Please send me your FSUIPC7.ini and FSUIPC7.log to nils[at]public-files.de after a flight you had problems with. <<<<
This is a FSUIPC7 Lua plugin, which dynamically plays the callouts you would hear from the pilot monitoring (PM) in an Airbus A320 series flight deck during takeoff and landing (including rejected takeoff, go-around and touch-and-go). It is to be used with the FENIX A320 series ONLY.
What it does:
- The plugin runs automatically upon loading the FENIX A320 add-on.
- Before takeoff, the V-speeds must be entered on the PERF page of one of the MCDUs (as usual).
- The following callouts are included:
- Takeoff: STABILIZED, FLEX SET / TOGA SET, AIRSPEED ALIVE, 100 KNOTS, VEE ONE, ROTATE, POSITIVE CLIMB, CLIMB SET
- Landing: SPOILERS, REVERSE GREEN, DECEL, 70 KNOTS, AUTOBRAKE OFF
- Gear confirmation: GEAR UP, GEAR DOWN
- Flaps confirmation: FLAPS UP, FLAPS 1, FLAPS 2, FLAPS 3, FLAPS FULL
- Special: STOP (rejected takeoff), STAND UP, GO (touch-and-go)
PMCO_FNX32X (Takeoff Demo) - YouTube
PMCO_FNX32X (Landing Demo) - YouTube
Important notes and prerequisites:
- Registered version of FSUIPC7 (for MSFS) is required! The free version is not sufficient, unfortunately!
- Please, follow carefully the included readme for installation instructions (PMCO and FSUIPC + WASM-module)!
On request, there is now also a video, guidung you through the installation: PMCO_FNX32X (Install Guide) - YouTube - If MSFS is run as admin, FSUIPC7 must also be run as admin. Either both or none!
Credits:
The default soundset was recorded by Nick Kidd. Big thanks to him!
This (my Lua plug-in) is free to use. However, if you like my work and wish to donate, it would be greatly appreciated: paypal.me/payNilsU
I wish you safe flights and happy landings!
I bought PSUIPC MSFS, I watched the videos and read the readme, when MSFS is launched (staem) FSUIPC also, I press the PERF key on my MCDU but nothing happens. I think I didn't do something correctly.
Can you help me?
2 days ago
1 hours ago
dermobb
Faize34
12 days ago
kotoritexture
22 days ago
22 days ago
dermobb
CAPTAINZAZEL
28 days ago
28 days ago
dermobb
PlanePusher
29 days ago
PlanePusher
29 days ago
29 days ago
dermobb
PlanePusher
1 months ago
1 months ago
dermobb
krzylisz
1 months ago
1 months ago
dermobb
nikita_567
1 months ago
1 months ago
dermobb
RyanZ225PC
1 months ago
1 months ago
dermobb
danns2001
2 months ago
1 months ago
dermobb
jjstevens1029
I hope you can make something out of it ..
2 months ago
2 months ago
dermobb
phbat
2 months ago
2 months ago
dermobb
J.PAULO
Just wanna tell u, that you still need the Fenix Quartz app for the exact readout of the v-speeds!
Otherwise, as you assuemd, PMCO is only reading out the fallback speeds!
2 months ago
2 months ago
dermobb
maxibk
2 months ago
2 months ago
dermobb
nikita_567